Materiał: Aluminium 7075 Powłoka: Matowa czarna twarda Powłoka Całkowita długość: 1.780" Całkowita szerokość: 1.1" Elementy montażowe: (2) Śruby płaskie 6-32, (1) Śruba 6-32 X 3/16 Pasowanie do czerwonego punktu: Trijicon RMR, Holosun HS507C Ten montaż pasuje do: Desert Eagle (po 2006 roku) EAA Witness Elite Match Ten montaż nie pasuje do: Rock Island 1911 Po prostu usuń tylną muszkę ze swojego pistoletu i zastąp ją naszym montażem, aby zamontować celownik red dot Trijicon RMR. Nie są wymagane żadne modyfikacje. Możesz zdjąć nasz montaż i wymienić tylną muszkę w każdej chwili. Elementy montażowe w zestawie. Instrukcje instalacji Usuń tylną muszkę* Zainstaluj montaż EGW w rowku Dokręć śrubę mocującą (jeśli dotyczy) Umieść celownik red dot na montażu EGW (umieszczenie małego kawałka papieru między celownikiem red dot a montażem ułatwi jego demontaż i zapobiegnie kontaktowi Loctite z celownikiem red dot.) Nałóż niebieski Loctite na dostarczone śruby montażowe Dokręć śruby montażowe do 15in/lbs 2 Śruby płaskie - Dostarczone do Trijicon RMR Śruby, które są dołączone do tego montażu wymagają klucza imbusowego 5/64'' do instalacji.
Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.