Ten montaż został zaprojektowany do użycia z celownikiem Williams FP-GR TK. Odpowiednie przednie przyrządy celownicze i blok od Williams to: Lyman Globe Front Sight, Williams Rear Sight. Od górnej części receivera do górnej części rowka przyrządu celowniczego jest .330". Od górnej części receivera do górnej części szyny picatinny jest .45". Ta szyna jest uniwersalna. Ten montaż jest frezowany po obu stronach, aby zapewnić miejsce na śruby w modelach leworęcznych i praworęcznych. Rowki picatinny biegną na całej długości szyny, co daje strzelcowi elastyczność przy montażu pierścieni celowniczych i innych akcesoriów. Kanał w środku zmniejsza całkowitą masę montażu. Ponadto, w wielu przypadkach, nie będzie on przeszkadzał w używaniu fabrycznych przyrządów celowniczych. Jednoczęściowe montaże celownicze EGW są oczywistym wyborem zarówno dla myśliwych, jak i strzelców taktycznych. Frezują je w swoim warsztacie, korzystając z jednego ze swoich ośrodków obróbczych. Po obróbce, montaż jest polerowany, piaskowany i anodowany typu II dla długotrwałej trwałości. Instalacja: EGW zaleca moment dokręcania 20 cali-lbs oraz kroplę niebieskiego loctite (loctite sprzedawany oddzielnie). Cały montaż i akcesoria (od śrub montażowych i klucza po opakowanie) są produkowane w USA.
This mount was designed for use with the Williams FP-GR TK peep sight. The corresponding front sight and block from Williams are: Lyman Globe Front Sight Williams Rear Sight Top of the receiver to the top of the rear sight dovetail is .330" Top of the receiver to the top of the picatinny rail is .45" This rail is ambidextrous. This mount is milled on both sides for bolt clearance on left or right handed models. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW's one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. They machine these in their shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately). The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.