Ludzkie oko nie jest w stanie wykryć, czy siatka celownicza jest wypoziomowana, jeśli kąt odchylenia wynosi 3 stopnie lub mniej, ale jeśli Twoja luneta jest odchylona o zaledwie 3 stopnie, to masz problem z dokonywaniem regulacji w siatce celowniczej podczas strzałów na dużych odległościach. Narzędzie do poziomowania lunet Fix It Sticks Scope Jack zostało zaprojektowane, aby prawidłowo ustawić Twoją lunetę i działa z każdym wkrętakiem o rozmiarze 1/4 cala! Wystarczy, że zamontujesz podnośnik do szyny Picatinny znajdującej się pod Twoją lunetą. Następnie obróć uchwyt napędowy, aż ramię podnośnika wejdzie w kontakt z płaskim miejscem pod Twoimi turbinami do regulacji windage i elevation. To zapewnia, że Twoja luneta jest idealnie wypoziomowana, a podnośnik utrzyma nacisk na tym płaskim miejscu, podczas gdy dokręcisz swoje pierścienie. Aby narzędzie do poziomowania lunet Fix It Sticks Scope Jack działało, musisz mieć krótką sekcję szyny Picatinny tuż pod korpusem lunety. W zależności od dostępnego miejsca, może być konieczne zdjęcie śruby ręcznej i zacisku, aby przesunąć podnośnik na powierzchnię montażową z boku. Fix It Sticks informuje, że musi być co najmniej 1/4 cala wolnej przestrzeni, aby użyć podnośnika.
The human eye can't detect whether or not a scope reticle is level if the degree is off by 3 degrees or less, but if your scope is off by just 3 degrees, then you're in trouble when it comes to making in-reticle adjustments for those long-range shots. The Fix It Sticks Scope Jack Leveling Tool is designed to get your scope set up right, and it works with any 1/4-inch driver! All you have to do is mount the jack to the Picatinny rail sitting underneath your riflescope. Then turn the drive handle until the arm on the jack engaged with the flat spot underneath your windage and elevation turrets. This ensures that your scope is perfectly level, and the jack will maintain pressure on this flat spot while you tighten your rings down. In order for the Fix It Sticks Scope Jack Leveling Tool to work, you have to have a short section of Picatinny rail sitting just underneath your scope body. Depending on how much clearance is available, you might have to take off the thumb screw and clamp to slide the jack onto the mounting surface from the side. Fix It Sticks says that there must be at least 1/4 inch of clearance to use the jack.