HORNADY
LEAD .38 CAL (.358") SEMI-WADCUTTER HOLLOW POINT HANDGUN BULLETS

090255104288 749010536

Pociski do pistoletów z ołowiu firmy Hornady są fabrycznie nasmarowane i formowane na zimno, co zapewnia ich całkowitą jednorodność i równowagę. Nasz wyłączny system knurlingu zatrzymuje smar na całej powierzchni oporowej, co redukuje osadzanie się ołowiu w lufie.

Więcej...

Hornady® lead pistol bullets are pre-lubricated and cold-swaged for total uniformity and balance. Hornady® exclusive knurling system retains lubricant over the entire bearing surface to reduce leading in Hornady® barrel. For cowboy shooters, authenticity is a strict requirement. That's why Hornady build Hornady® Cowboy™ bullets to SASS (Single Action Shooting Society) specifications while holding them to the same stringent production standards as all Hornady® products. PRODUCT FEATURES CLASSIC & CONVENTIONAL DESIGN Traditional conical and flat designs have perfect symmetry when combined with knurling at the base of the bullet, which deliver increased stability and accuracy. This ensures proper positioning in authentic revolvers, with no unwanted nicking of primers as the cylinder turns. SPECIAL KNURLING AND GREASE RING The knurling system holds an even distribution of lubricating wax over the bearing surface of the Cowboy™ bullet, resulting in less leading.

Więcej...

Oceny klientów dla HORNADY LEAD .38 CALIBER (0.358") 158GR SWC/HP 300/BOX

Liczba ocen: 6
Od brownells.com: 6
Średnia ocena: 4

Excellent Bullet for Taurus Judge (28-05-2013)

This is one of a very few bullets that give acceptable accuracy--say 3-4 inches for 5 rested shots at 25 yards--from the Taurus Judge/Public Defender. This 45/410 revolver typically has 0.462" cylinder throats and a soft lead 0.454" bullet like this one, loaded long, is needed to center in the bore. More at http://www.thesixgunjournal.net/the-taurus-public-defender-45-colt410-snubnose-revolver/

Excellent High Performance Bullet (21-04-2014)

These Hornady swaged bullets come with a bit of Carnauba powder sprinkled over them. Okay for bullseye shooting at up to 750fps but not much else.

I put about a third of a teaspoon of Johnson's Paste Wax (the brown type that has carnauba - not the new type without carnauba) into a 1 quart ziploc bag and slowly, gently, carefully roll about a hundred of the bullets in the bag with the paste wax. The wax gets evenly dispersed in about 2 minutes of rolling.

I then pour the bullets out onto a paper towel, separate them and let them dry. When they are thoroughly dry they become MAGIC, and shoot at up to about 1100fps without leading, and with phenomenal accuracy.

These bullets feed flawlessly even in 100 year old 1911's.

Good Bullet (17-06-2012)

These are good bullets, but not great. I've used them in the .44 Magnum at around 850 fps and they lead the bore at that velocity. Also, the powdered lubricant is pretty messy while loading and builds up in the seater die. They do however, produce good accuracy.

Good bullet to practice with (18-12-2013)

I use this Hornady 240 gr. SWC for .44 Mag target shooting, usually knocking over bowling pins. Easy to load, much more economical and far more painless to shoot compared to jacketed .44 bullets. I never found a need to load .44 Specials for target practicing with my S&W 629. I found that my regular .44 Mag brass with these bullets works just fine. These lead bullets are lubed well enough to prevent any leading so long as you follow the Hornady manual powder recommendations for max loads. W231 is my favorite powder in my reloads using these bullets as well as Win. Large Pistol primers. Keep in mind that .44 Mag rounds still require a heavy crimp even when using lead bullets.

Excellent bullet (16-09-2011)

This is a quite accurate bullet in front of 3.9 grs of Unique. It doesn't lead the barrels of my S&W 19 or Ruger SP101. It's also quite economical--even more so than my favorite plated bullets for .38

Extremely poor quality and performance (25-06-2016)

Horrible product. No quality control and obviously a low end product. All projectiles varied by as much as .356-,360" Accuracy was absolutely horrendous with all combinations of powders, etc. I wish I had my money back since its pretty much useless. All it does is leave the barrel of your gun. Where it ends up is like spinning a top. Very disappointed with this Hornady product. I guess I can melt em down and use to make fishing weights. Don't know about the other positive reviews. Take your chances if you buy.

Zobacz 6 dodatkowych opinii na brownells.com

0 0 1 PLN

Nr produktu: 749010536
HORNADY LEAD .38 CALIBER (0.358") 158GR SWC/HP 300/BOX
Numer części: 10428 090255104288 Pociski do pistoletów z ołowiu firmy Hornady są fabrycznie nasmarowane i formowane na zimno, co zapewnia ich całkowitą jednorodność i równowagę. Nasz wyłączny system knurlingu zatrzymuje smar na całej powierzchni oporowej, co redukuje osadzanie się ołowiu w lufie.

Powiadom o dostępności

Niedostępne.

Specyfikacja: Bullet Style: Semi-Wadcutter (SWC) Caliber: 38 Caliber Diameter (in): 0.358 Grain: 158 Ilość: 300

Dodaj do listy zakupów

Zapytaj

Szczegóły

Dodaj do listy zakupów

Zapytaj

Top takeaways

Pociski Hornady są fabrycznie nasmarowane i formowane na zimno, co zapewnia ich jednorodność i równowagę.
System knurlingu zatrzymuje smar na całej powierzchni oporowej, redukując osadzanie się ołowiu w lufie.
Specyfikacja: Kaliber .38, styl pocisku Semi-Wadcutter (SWC), masa 158 grain, średnica 0.358 cala.

Cechy

Grany: 158 Kaliber: 38 Caliber Nazwa pocisku: Semi-Wadcutter (SWC) Średnica (w calach): 0.358 Ilość: 300 Waga dostawy: 3,175kg Wysokość wysyłki: 69mm Szerokość wysyłki: 107mm Długość wysyłki: 142mm UPC : 090255104288