Ręczne narzędzie skrawające z węglika, które łatwo przycina nadmiar materiału z dolnego ucha lufy podczas dopasowywania luf niestandardowych lub fabrycznych do pistoletów 1911. Te narzędzia usuwają materiał z ucha lufy w sposób równoległy, z odpowiednią wysokością i promieniem, aby uzyskać jak najlepsze dopasowanie. Zaleca się najpierw użycie narzędzia o średnicy 0.186”, a następnie przejście do narzędzia o średnicy 0.195”, jeśli trzeba usunąć więcej materiału. Następnie należy starannie dopasować ręcznie, aby uzyskać mocne, nienaładowane dopasowanie lufy do zamka. Zaczynaj od małych ilości i często sprawdzaj swoją pracę. W niektórych kombinacjach zamka/lufy, narzędzie o średnicy 0.195” może usunąć więcej materiału niż to konieczne. Pasuje do wszystkich pistoletów 1911 Auto, Commander, Officer, jednolitych i podwójnych ram. Narzędzia o średnicy 0.186” i 0.195” są dostępne z lub bez uchwytu. Uchwyt jest również dostępny osobno.
A hand operated, carbide cutter easily trims excess material from the bottom barrel lug when fitting custom or factory barrels to 1911 autos. These cutters remove material from the barrel lugs in a parallel fashion, and with the correct height and radius, to help produce the best possible lockup. It is recommended to use the 0.186” cutter first, then progress to the 0.195” cutter if more material needs to be removed. Follow with careful hand fitting to achieve a firm, non-binding barrel-to-slide fit. Start small and check your work often. It is possible, with some slide/barrel combinations, that the 0.195” cutter could remove more material than necessary. Fits all 1911 Auto, Commander, Officer, single and double-stack frames. The 0.186” Lug Cutter, and 0.195” model are available with or without the handle. The handle is also available individually.